24
Component Replacement Guide
Replacing an I/O Module
To stop players that use the I/O module you wish to replace:
1. From SystemManager, click the
Player Configuration
button in
the left-hand column to view the
Player Configuration
window.
2. From the
Player Configuration
window, click the icon for the
Omneon MediaDeck which contains the I/O module you wish to
replace. The
Player List
window appears showing a list of players
that reside on the selected Omneon MediaDeck.
3. Click the check boxes next to the Players that use the I/O module
you wish to replace. Then click the
Deactivate Selected
button.
4. Verify which players use the I/O module to be replaced by clicking
the
Edit
link for each player, and then clicking
Attached Devices
.
The
Device
column displays all attached devices.
5. Uncheck the
Attach
check box for the I/O module to be replaced.
Then click
Done
.
6. Repeat
for all tracks of the Player associated with that
respective I/O module.
NOTE:
Once the new I/O module is installed, you must attach the new
device to the players, and then re-activate the players.
Verifying Which I/O Module to
Remove
If you are using more than one Omneon MediaDeck, use the
Wink
function to identify the Omneon MediaDeck that contains the I/O
module to be replaced, and then wink the I/O module to identify the
correct one. If you have already identified the correct Omneon
MediaDeck, continue to
Summary of Contents for Omneon MediaDeck
