26
Component Replacement Guide
Replacing an I/O Module
Removing the I/O Module
Removing the I/O Module from the Chassis
To remove an I/O module from the chassis:
1. Disconnect any cables from the I/O module.
2. Using a screwdriver, loosen the three screws on the rear panel of the
I/O module as shown. The screws are captive and will not come
out completely.
Figure 12 Loosening the I/O Module Screws
3. Using both hands to grip the screws, gently pull out the I/O
module from the chassis as shown in
.
Loosen
three screws
Summary of Contents for Omneon MediaDeck
