Chapter 2: MediaDirector 2252B/2251B component replacement
c. Press gently on the back of the riser assembly first, then the front, until both edge connectors are
firmly seated in their riser slots.
IMPORTANT:
If the edge connectors are not aligned properly, lift up the assembly
and attempt to install it again. Do not rock the riser assembly into position. Doing so
may damage the contact pins within the riser slot.
d. Reconnect the internal cable to the front of the LTC card.
Replacing the Ethernet card in PCI Riser 3
When installing the riser assembly, be careful not to rock the riser assembly into place on the server
board. Doing so can damage the contact pins within the riser slot.
NOTE:
The specific card you are replacing may be in a different PCI slot position than that
which is shown in the images in this section.
1. Remove PCI Riser 2-3 assembly as follows:
a. Disconnect the internal cable from the front of the LTC card.
b. Grasp PCI Riser 2-3 assembly with both hands and pull the riser assembly out of the riser slot,
being careful to clear the LTC connector away from the rear panel before lifting up.
22