Replacing an optical 10GbE I/O module
d. Secure the module to the chassis using the three screws.
4. Install PCI Riser 1 assembly as follows:
a. Grasp the riser assembly with both hands and lower the front end of the riser assembly first,
aligning the riser edge connector with the corresponding riser slot on the server board.
b. Lower the back end of the riser assembly, lining up the tabs on the faceplate with the holes on the
back panel of the chassis.
c. Press down on the riser assembly bracket and faceplate until firmly seated.
CAUTION:
Do not rock the riser assembly into place. Doing so may damage the
contact pins within the riser slot.
Installing the system cover
The server system must be operated with the system cover in place to ensure proper cooling.
1. Place the system cover onto the chassis and slide forward until the front edge of the system cover is
pressed up against the back edge of the front drive bay.
2. Hand tighten the two captive thumb screws at the back of the chassis.
3. Using a screwdriver, install the top cover screw(s).
Example:
35
MediaDirector Component Replacement Guide
