Spectrum
34
4. Separate hazardous materials from the remainder of the material.
a. Sort hazardous materials into their different types (i.e., batteries, hazardous liquids, hazardous
solids, fiberglass, etc.).
b. Proceed with hazardous waste management processes only.
5. Identify re-usable materials/sub-assemblies and separate these from the rest of the material.
6. Identify and separate recyclable materials as per below examples:
a. Scrap material to be sent to smelter(s).
b. E-waste such as displays, CPU's, cables and wires, hard drives, keyboards, etc.
c. Metals such as steel, brass, and aluminum.
d. Plastics such as fan casings, housings, covers, etc.
e. Fiber optics and plastic tubing not containing electrical or data wiring.
Safety rules (English)
Recycler personnel are to wear personal protective equipment including proper eye protection, proper
hand protection, and proper breathing protection if needed.
Recycler personnel shall be experienced with using the proper tools required for disassembling
equipment. Untrained personnel shall not disassemble Harmonic products. Unfamiliarity with tools can
cause damage and injury.
Règles de sécurité
Le personnel du recycleur doit porter de l'équipement de protection individuelle, y compris des lunettes,
des gants et un masque de protection appropriés au besoin.
Le personnel du recycleur doit avoir de l'expérience des outils de démontage de l'appareil. Les produits
Harmonic ne doivent pas être démontés par du personnel non qualifié. Une mauvaise connaissance des
outils peut causer des dommages et des blessures.
EU manufacturer’s Declaration of Conformity
This equipment is in compliance with the essential requirements and other provisions of Directives 73/23/
EEC and 89/336/EEC as amended by Directive 93/68/EEC.
NOTE:
For specifics, about which standards have been applied, refer to the Declaration
of Conformity of the product on Harmonic website at
or
contact Harmonic Compliance Team at
regulatory.compliance@harmonicinc.com
Electromagnetic compatibility notices – Class A
1. FCC verification statement (USA)
