Spectrum X front panel
Spectrum X control panel
The Spectrum X control panel provides basic system status.
Figure 4-4: Spectrum X control panel
Key
Button/Indicator
Description
1
System ID button with
integrated LED
The identification button can be used to locate a
particular system within a rack. When this button is
pressed, the ID LEDs on the front panel and on the
back edge of the server board (viewable from the
rear panel) flash until the button is pressed again.
2
Non-maskable interrupt
(NMI) button (recessed,
tool required for use)
The NMI button can be used to put the server into a
halt state when diagnosing an issue. To prevent an
accidental system halt, the physical button is located
behind the Control Panel and is only accessible with
the use of a small tipped tool.
3
NIC 0 Activity LED
4
NIC 1 Activity LED
When a network link is detected, the LED will turn
on solid. The LED blinks when data is being sent or
received over the network.
5
System cold reset button
(recessed, tool required
for use)
When pressed, this button initializes a hard system
reset. To prevent an accidental reset, the physical
button is located behind the Control Panel and is
only accessible with the use of a small tipped tool.
101
Spectrum System 8.4 Installation Guide
