Chapter 8: ChannelPort module hardware reference
Key
Component
Description
15
Gigabit Ethernet Port
Not applicable for systems running 8.4 and later
software; only systems running 8.3.x.x and earlier
software use this port.
16
Gigabit Ethernet Port
Used only in MediaPort 7000.
Related information
About MediaPort 7000 and ChannelPort timing
on page 156
GPIO/RS-422 connector signal assignments
on page 181
ChannelPort 8100 rear panel: Standard Channel mode
Review to the diagram and the table for details on the rear panel component functionality when
theChannelPort 8100 is in Standard Channel mode.
Figure 8-2: ChannelPort 8100 rear panel (Standard Channel mode)
Key
Component
Description
1
External Input 1 Channel A
Use for video input on Channel A.
2
Video Output Channel A
(Primary)
Use for primary video output or for HD-branded
output when in Independent Branding mode on
Channel A. Refer to “Configuring a ChannelPort
channel” in the
Harmonic SystemManager User
Guide
for instructions on configuring Independent
Branding mode.
3
Video Output Channel A
(Secondary)
Use for secondary video output or for SD-branded
output when in Independent Branding mode on
Channel A.
4
External Input 1 Channel B
Use for video input on Channel B.
174
