Chapter 9: MediaStore 5100 and 5000 series hardware reference
Key
Component
Description
2
I/O Modules
The MediaStore contains two
I/O Modules
for interfacing
to additional MediaStores via SAS connection. Both
modules are the same (mechanically and electronically).
Each module includes three SAS ports and Status LEDs.
• The
Primary I/O Module
is installed in the top bay
(facing the rear).
• The
Secondary I/O Module
is installed
upside-down
in
the bottom bay.
MediaStore 5100 series I/O module components
Two Input/Output (I/O) Modules are mounted in the rear of the MediaStore. Both modules are the same
— mechanically and electronically. The
Primary I/O
module is the module installed in the
top
slot. The
Secondary I/O
module is the module installed in the
bottom
slot.
Figure 9-7: MediaStore 5100 series I/O module
Key
Component
Description
1
I/O Module Fault
LED
The I/O Module Fault LED states are described in “MediaStore
5100: I/O module status LEDS”.
2
I/O Module OK
LED
The I/O Module OK LED states are described in “MediaStore
5100: I/O module status LEDS”.
3
SAS Link Activity
LEDs
The SAS Connector Activity LEDs are described in “MediaStore
5100: SAS link activity LEDs”.
4
12 Gb/s SAS
connectors
Each I/O module has three SAS connectors, with 4 links per port.
5
Ethernet
connector
For Service Use only
6
For Service Use
Only
For Service Use only
5
Handle
Each I/O module includes a Handle that is used for removing and
inserting the module.
Refer to the
Spectrum MediaStore Component Replacement
Guide
for operating instructions when replacing an I/O Module.
200
