Safety rules (English)
Safety rules (English)
Observe the rules for safe product disposal and recycling.
Recycler personnel are to wear personal protective equipment including proper eye protection, proper
hand protection, and proper breathing protection if needed.
Recycler personnel shall be experienced with using the proper tools required for disassembling
equipment. Untrained personnel shall not disassemble Harmonic products. Unfamiliarity with tools can
cause damage and injury.
Règles de sécurité
Respecter les règles d'élimination du produit en toute sécurité et le recyclage.
Le personnel du recycleur doit porter de l'équipement de protection individuelle, y compris des lunettes,
des gants et un masque de protection appropriés au besoin.
Le personnel du recycleur doit avoir de l'expérience des outils de démontage de l'appareil. Les produits
Harmonic ne doivent pas être démontés par du personnel non qualifié. Une mauvaise connaissance des
outils peut causer des dommages et des blessures.
EU manufacturer's Declaration of Conformity
Learn more about Harmonic product regulatory compliance.
This equipment is in compliance with the essential requirements and other provisions of Directives 73/23/
EEC and 89/336/EEC as amended by Directive 93/68/EEC.
NOTE:
For specifics, about which standards have been applied, refer to the Declaration
of Conformity of the product on Harmonic website at
or
contact Harmonic Compliance Team at
regulatory.compliance@harmonicinc.com
Electromagnetic compatibility notices – Class A
Learn more about Harmonic product electromagnetic compatibility.
1. FCC verification statement (USA)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
users will be required to correct the interference at their own expense.
243
Spectrum System 8.4 Installation Guide
