19
Adult assembly: 2 x Phillips Screwdrivers required.
1. Locate both sets of screws with plastic knob, washers
and plastic encased inner bolts (Part T) in the
hardware bag and set aside.
2. Locate the 1.3 cm (0.5 inch) connector rod screw and
washer (Part X) in the hardware bag and set aside.
3. Identify the 22.3 cm (8.8 inch) backrest connector rod
(Part W) pre-installed in base of backrest. Remove
and set aside.
4. Place
the
backrest and
base face down
and slide the
base plate
between the
two backrest
anchor points.
Pass the 8.8
inch (22.3 cm)
connector rod
through assembly. Insert the washer and 0.5 inch (1.3
cm) screw on opposite side and tighten ❶.
TIP
: If connector rod does not pass through easily, make
sure it is aligned with holes and tap screw head
lightly to guide it through the plastic.
5.
Turn assembly face-up and pull
the backrest up into the vertical
position. Pull up-front adjuster
tight to hold the backrest in place.
Connect the backrest to the base
in the upright position, ensuring that the backrest
ASSEMBLING/DISASSEMBLING CHILD RESTRAINT
Backrest
anchor points
Connector
rod
Base
plate
❶
Part ‘X’
(screw &
washer)
❷
Summary of Contents for DEFENDER 360
