Component Name:
A---Spray Nozzle B---Water Filling Hole C---Steam Regulator D---Burst Steam Button
E---Spray Button F---Thermostat Dial G---Water Reservoir H---Power Indicator Light
I---Soleplate
Filling With Water:
1. Set the steam regulator to 0(=no steam)(only for steam iron).
2. Hold the iron by hand and slant the iron with 45°down.
3. Fill the water in the box through the Water-Filling Hole, if the water is too hard, it is advisable to use
distilled water, do not put the chemically water in the water reservoir.
4. Wipe off the water over the box; pour out the remaining water after use.
Dry Ironing:
1. Before running the iron, please classify the clothes as per its washing label, as it will be quicker for
the iron to heat up that to cool, the clothes (such as synthetic fabric, silk etc)with lower ironing
temperature shall be ironed firstly, and then iron the clothes(such as wool, cotton and linen etc)with
higher temperature.
2. Stand the iron on its end, and turn the thermostat dial to the MIN position.
3. Plug in the iron and select the temperature by turning the thermostat dial. If there is water in the
reservoir, turn the steam regulator to OFF position. Wait until the indicator light goes off showing that
the required temperature ha been reached.
Steam Ironing:
1. Fill water in the iron as per the water-filling methods.
2. Plug the appliance in the socket.
3. If only set thermostat dial to MAX position as per the temperature indicator, steam iron will be
available, otherwise water may leak from the soleplate.
4. It indicates that the temperature has been ready until the indicator light goes off.
5. Set the steam regulator correctly, increase the steam output by rotating the steam regulator
anticlockwise. otherwise decrease.
Caution: Synthetic Fabric, Nylon, Synthetic Silk and Silk cannot use the steam iron.
otherwise it will damage the finish of surface.
