Burst of Steam:
This function will be able to provide more steam to remove stubborn creases.
1. Set the thermostat dial button to MAX until the indicator light goes off.
2. Release the steam by pressing the steam button.
3. Wait for several minutes and let the steam penetrate through the fabric, and then release more
steam through pressing this buttons again.
Note:
1. There should be 3-5 seconds rest between two times of pressing Steam Button in order to obtain
the best steaming result.
2. Fill the water to the MAX position before using this function.
3. In order to prevent the water leaking from soleplate , please do not press the steam button
continuously with more than 5 seconds.
Spraying Methods:
1. Fill the water in the iron as per water-filling methods.
2. Press water spray button.
3. Note: No matter what steam ironing of dry ironing is, spray will always be available in any case.
Type of Fabric and Thermostat Dial Form:
Caution:
Please note that
on the label means that this article may not
ironed.
Instructions on Label Type of Fabric
Thermostat dial
Nylon Silk
MIN
MAX
Wool
Cotton
Linen
Caution:If the fabric consists of various kinds of fibers, always select the lowest ironing temperature of
the composition of those fibers.
After Ironing:
To extend the working life of the iron, whenever you finish ironing, you are recommended to
empty the reservoir as follows:
Unplug from the mains socket. Empty the iron. Shake it lightly above a sink. To dry the remaining
moisture, turn the iron on again with the thermostat dial in the MAX position with steam regulator in MAX
position until Power Indicator Light goes off. Unplug from the mains socket and allow to cool. Clean the
plate with a dry cloth as traces of moisture could mark it.
