45
and unhook loops from plastic
base.
3. Gently slide fabric cover off the
backrest.
Base
:
4. Locate elastic fabric loops (x2) and
snaps (x2) along base and detach
from child restraint.
5. Gently slide fabric cover off the plastic base from the
back of the child restraint towards the front of the
seat.
TO INSTALL:
To reinstall fabric pads, repeat previous steps in reverse
order.
TIP
:
For ease of fabric pad installations, turn recline knob
counterclockwise to open gap at base of backrest to
facilitate passing the hook and loop tabs through
the gap to secure.
! WARNING
: Reinstall harness system if applicable (see
“Removing/Installing harness”, pg. 37).
INSTALLING CUP HOLDER
(WHEN APPLICABLE)
1. Determine on which side you
would like the cup holder to be
installed. When installing child
restraint in a rear side seat, install
cup holder away from car door.
2. Locate the plastic protrusion on
either side of the child restraint
base.
3. Insert cup holder over plastic protrusion and pull
down until locked into place.
4. Lift to remove.
