- 10 -
V6-04-05
Assembly instructions Veranda sunblind VZ520
D19. Running the motor to its stopping point:
Let the motor run until it switches off.
Check that the motor stops where it should, not touching the end pulley on the guide rail. The motor is
not adjusted.
Both buttons on the motor are completely pushed down ex-works (if not push them down both). The
motor will not stop by itself.
Let the blind run out until the chosen lower position is reached. Then turn the switch for the test cable
to its neutral position.
Next push the white or yellow button (depending on the built-in side), so that the button lifts up.
The lowest position is now adjusted.
