- 5 -
V6-04-05
Assembly instructions Veranda sunblind VZ520
Attention:
Only couple the spindles as allowed. Given that the power of the motor is selected according
to the number of blinds to be operated, the number of blinds connected up must match the number
allowed for the motor.
For this reason, end brackets not supplied with a connector are covered by a self-adhesive patch.
D9. Positioning the awning:
Slide the entire sun blind assembly over the wooden blocks upto the right position. (Which may be
hard against the wall). Take care that the verandaprofiles are at right angles regarding to the wall. We
are working with a squared-off system.
D10. Unwinding the cables:
Unwind the cable so that there are no loops or kinks. Check that at least 2 or 3 turns of cable are left on
the cable pulley. Mind that the cable unrolls along the bottom side.
Connect the motor cable up provisionally using a test cable and let the endprofile run out for +/- 15cm