- 7 -
V6-04-05
Assembly instructions Veranda sunblind VZ520
D14. Positioning the cables:
Position the endprofile in equal height with the guide rails, and insert the endprofile a short way into
the rail. Position the guide rail in front of the pins on the mounting bracket. Make sure that the cable
is feeding cleanly throughout. Then pull the cable at point E, and the guide rail slides on to the pin by
itself.
Do the same for all the guide rails.
D15. Fixing the sun blind in the supports:
Position the sun blind in the supports, and screw the supports hand-tight by using the screws sup-
plied.
Remove the wooden blocks.
D16. Placement of the intermediate rolls:
In case of using intermediate rolls, by extremely large extension, the brackets are placed just under-
neath the guides. The intermediate rolls must be placed in line to each other and rather in the middle
of the lateral guide.
D17. Tensioning the spring:
Position the endprofile in the highest position and make 2 marks in the endprofile the distance apart R
shown in the separate table.
The maximum distance depends on the spring supplied, the used fabric, the diameter of the roll for
fabric and the extension of the blind.
Make sure the marks are always at the same distance from the centre of the endprofile.
Attention:
The awning will be put on tension now. Pleace work carefully and safe!
