- 8 -
V6-04-05
Assembly instructions Veranda sunblind VZ520
Feed the cable round the pulley (through the fork) and insert the cable through the hole in the right-
angled bracket on the end of the endprofile. Feed the cable back through the second hole and tighten
the cable clamps on the cable behind the right-angled bracket so that the axle of the pulley is against
the marks in the endprofile. (See fig.)
Check carefully the feed of the cable over all the pulleys both on the front of the guide rail, as well as at
the endprofile slider block and the cable feed pulley.
Pay attention to the symmetry of the spring.
D18. Inserting the spring:
The awning is still in its highest position. Check that the cable doesn’t cross over at the cable pulley,
but running cleanly side by side. Thread the spring into the forks of the pulleys and insert the cable
into the cable unit. Make a knot in each cable, behind the clamp unit. The sun blind is now under
tension.
Remark concerning the motor:
If the motor is a standard SLT type, then you can proceed with reading these instructions.
If the motor is an Orea or an Altus RTS, please consult the enclosure of the concerned motor.
