TV 40
TV 40
10
11
Broom height
The broom height needs to be adjusted so
that the broom is touching the top of the
grass.
The broom height is determined by the
caster wheels that it rides on. The caster
wheel is attached with bolts located in
slotted adjustment holes.
To adjust:
•
Remove caster wheel mounting bolts.
•
Adjust caster wheel to achieve desired
broom height and tighten bolts.
Note
: Brooms are originally 12” in
diameter. When the broom wears to 10”
the adjustment will not lower the broom
enough for it to perform adequately and
needs to be replaced. Part # 973001
Hopper Door Latch
Adjustment of the hopper door latch
should never be necessary. If the hopper
door won’t latch or the hopper door does
not seal against the hopper there are
adjustments that can be made. There are
shims that bolt on with the strike plate that
can adjust the depth of the latch. It is
possible to add or remove shims to make
the door close properly.
Height Adjustment
For best performance the Turbo Vac must
be operating at the correct height. At the
correct height the debris flap touches the
top of the grass.
Adjustments
Hose Option (900217)
1.
Open the Hose Door by loosening the
wing nut and swiveling the door down
to the next notch.
2.
Close the Flap. This blocks off air
intake from underneath and creates
suction in the hose.
3.
Begin using hose.
The height can be easily adjusted up or
down by using the ratchet jack.
