Harrie Leenders Fuga eL Instructions for Installation, Use and Maintenance
19
General instructions and regulations
The installation of the Fuga eL with decorative casing must be carried out by a skilled
person employed by a dealer recognized by Harrie Leenders Haardkachels.
The casing parts are susceptible to scratching. Handle them gently.
After the stove has been properly installed, burn some kindling wood to check the
draught.
Please Note, the Fuga eL has been tested by the manufacturers on a 3m straight flue.
Safety recommendations
Glass tends to break easily, and broken glass is quite sharp. Therefore take adequate
safety precautions.
For general safety, we refer to guidelines or regulations issued by a relevant official body
Materials and tools required
Crosshead screwdriver
Flathead screwdriver
Boxspanner set
Hexagonal wrench set
Materials included
4 S6 plugs
4 stucco screws
Set of masonry bits Knife
Plumb line Sliding pieces
4 selftapping screws 0 3.5 x 9.5 (+2 spares)
Spirit level Handtruck
Singlewalled pipe and accessories (connector)