GB 19
InstallatIon InstruCtIons Pharos InterIor
• The installation of the Pharos Interior with decorative casing must be carried out by a skilled person employed by a dealer recognized by
Harrie Leenders Haardkachels.
• The casing parts are susceptible to scratching. Handle them gently.
• After the stove has been properly installed, burn some kindling wood to check the draught.
Safety recommendations:
• Glass tends to break easily, and broken glass is quite sharp. Take therefore adequate safety precautions.
• For general safety, we refer to guidelines or regulations issued by a relevant official body.
• Note: ensure there is no inflammable and/or explosion-hazardous material in or on the stove such as a spray can, packing material or the like.
Materials required
• 4x Treaded rod M8 (L=1000)
• 4x Bodywork-ring M8
• 7x Bolt M8x20 (Hex. wrench)
• 5x Bolt M6x20 (Hex. wrench)
• 3x Bolt M4x8 (Crosshead)
• 1x Nut M6
• 8x Nut M8
• 1x Bolt M6x75 (Hex. wrench)
• 1x Self-locking nut M6
• 3x Bodywork-ring M6
Tools:
• Open-end / socket spanner j.w. 10
• Open-end / socket spanner j.w. 13
• Socket-head wrench 3
• Crosshead screwdriver
• Spirit level
• Drilling machine
• Concrete bit Ø 6
• Concrete bit Ø 14
• Handtruck
• Plumb line
• Step ladder (for 2 persons)
1x mounting ring
1x ceiling-floor support plate
1x pipe with ring plate
1x stove-pipe support
1x ball-holding ring
1x flap-control handle
1x decorative pipe
1x finishing cover
1x pre-assembled frame
1x Pharos lifting jack
1x stove pipe
1x bearing plate
1x lower shell
2x shell parts
1x Spark screen
1x column
16x balls (+ 3 spares)
Materials and tools required
Auxiliary tools (separately available)
Summary of Contents for PHAROS INTERIOR
Page 2: ......
