Harrington Signal HS-3100 Programming Manual Download

Page: 30 / 64

HS-3100/3200 Programming Manual

The Dialer Settings window has the following push buttons along the right side:

•

Exit:

Close the Dialer Settings window and return to the IDs window.

•

Configuration 1:

Display the Dialer Configuration 1 dialog.

•

Configuration 2:

Display the Dialer Configuration 2 dialog.

•

Call Directions:

Display the Call Directions dialog.

•

Zone Data:

Display the Zone Data dialog.

•

Maintenance/Common:

Display the Dialer Maintenance and Common Reporting Codes

dialog.

Dialer Configuration 1

The

Dialer Configuration 1

dialog (see

Figure 11

)

contains the First
Communicator Options,
Second Communicator
Options and International
Options.

The

Communications

option

determines if the dialer will
communicate to the central
station. When Enabled is
selected, the dialer will
communicate all events as
programmed. When
Disabled is selected, the
dialer will not communicate any events.

The

TLM One/Two Check

options determine whether the dialer will test for telephone line faults on

line one and line two respectively.

The

Third Phone #

can be programmed for two different modes of operation. When Alternate

Dialing Enabled is selected, the dialer switches between the first and third telephone numbers
after each dialing attempt, until the maximum number of dialing attempts have been made to each
number. When Third Number Backup is enabled, the dialer will use the third telephone number
only if all attempts to communicate to the first telephone number fail. If all attempts to
communicate to the third number also fail, a failure to communicate trouble will be generated.
When Disabled is selected, the third telephone number is not used.

The

Dialing

option has three different options for pulse or DTMF dialing. If All attempts Pulse is

selected, the dialer will always use pulse (rotary) dialing. If All attempts DTMF Dialing is selected,
the dialer will always use DTMF dialing. If 4 attempts DTMF then Pulse is selected, the dialer will
use DTMF dialing for the first four attempts. If unsuccessful, the dialer will switch to pulse (rotary)
dialing for the remaining attempts.

The

SIA Rep. Codes

option determines whether the dialer will send the automatic reporting codes

that are in the dialer, or use the reporting codes that are programmed in the

Zone Data

and

Maintenance/Common

reporting codes sections. See See “7.0 Appendix D: Table of Reporting

Codes” on page 56 for a list of the automatic SIA Reporting Codes.

The

SIA Max Events

option sets the maximum number of events the dialer will send for one SIA

transmission. When 20 per Round is selected, SIA sends a maximum of 20 events per round.
When 8 per Round is selected, SIA sends maximum of 8 events per round.

The

Contact ID Rep. Codes

option determines whether the dialer will send the automatic reporting

codes that are in the dialer, or use the reporting codes that are programmed in the Zone Data and

Figure 11: Dialer Configuration 1