MM-015371-001, Rev. C
53
3.
Make a service loop in the cable near the back of the control head.
4.
Route the cable from the rear of the control head to the weather-resistant motorcycle radio case. If the
control head is mounted on the motorcycle’s handlebars, leave sufficient slack in the cable to allow
for full handlebar steering/travel without any stretching of the cable. Protect the cable from chafing.
Figure 10-1: CAN Terminators and Control Head-to-Radio CAN Cable Connection
5.
Route the CAN cable it into the case by passing it through the square hole in the bottom floor case.
6.
Mate this end of the cable to one of the two CAN port connectors on the rear panel of the radio.
7.
Mate another CAN terminator to the other CAN port connector on the rear panel of the radio. This
action makes the CAN termination at the radio-end of the CAN link.
8.
Loop, tie and stow the excess cable as necessary, leaving a service loop at the back of the radio and at
the back of the control head.
