QSEE6800
+
H Installation and Operation Manual
19
Chapter 2: Installation
7. On the
Device
tab of the
Navigation Properties
box, enter the IP
address of the frame that holds the module. (See
Figure 2-8.
Navigation Properties Box
8. In the third field, enter:
1.0.[slotnumber]
(Where, for example, 1.0.5 would refer to the module in slot 5 of
the frame.)
9. Close the window.
CAUTION
Do not make changes in the last field (located above
and to the right of the Set Default button.) Making
changes to this field could cause loss of
communication between the module and your CCS
software. If communication is lost, you will need to
rediscover the module.
Do not make changes in
this field
Enter frame IP address here
