10
QSEE6800
+
H Installation and Operation Manual
Chapter 2: Installation
Setting the Jumper
The QSEE6800
+
H module has one standard jumper (CJ1). You can set
the jumper to configure the outputs remotely on a PC, or locally.
Figure 2-1.
Location of the CJ1 Jumper
Follow this procedure to set the
CJ1
jumper for either local or remote
control:
1. Locate jumper
CJ1
on the module (beside the extractor handle).
shows the standard location of the
CJ1
jumper.
2. Place a jumper on pins 1 and 2 to set the module for
Remote
control, or pins 2 and 3 to set the module for
Local
control. See
Figure 2-2.
The CJ1 Settings for Local and Remote Control
Jumper CJ1
Note
You need to configure
modules for local or remote
operation
prior
to power-up.
To change the configuration,
first remove power from the
module, reset the jumper,
and then reapply power.
The white triangle near the
jumper pins on the module
indicates pin 1.
Remote control setting
Local control setting
3 2 1
3 2 1
