QSEE6800
+
H Installation and Operation Manual
11
Chapter 2: Installation
Installing QSEE6800
+
Modules
Required Frames and Back Connector Types
There are two types of modules:
•
Triple-slot back connectors
•
Front modules
Back connectors for this module come in the triple-slot size. Up to six
front modules can fit in an FR6802
+
frame if they are connected to
triple-slot back connectors (three spaces are required to accommodate
the extra width of the back connector).
Installing QSEE6800
+
H Modules
QSEE6800
+
H modules require no specialized installation procedures.
However, if installing both front and rear modules, ensure that the back
module is installed first before plugging in the front module.
See the
FR6800
+
Frame Installation and Operation Manual
for
information about installing and operating an FR6802
+
frame and its
components.
Removing 6800
+
Modules
These modules require no specialized removal procedures. However, if
removing both the front and rear modules, ensure that the front module
is unplugged from the frame first, before removing the rear module.
See the
FR6802
+
Frame Installation and Operation Manual
for
information about removing components in an FR6802
+
frame.
CAUTION
Before installing your modules, see
Frame Power Ratings” on page 8
.
Note
Modules are hot-swappable and
can be removed or replaced
without powering down the
frame.
