22
QSEE6800
+
H Installation and Operation Manual
Chapter 3: Card-Edge and Parameter Operation
Operating Notes
When setting the control parameters on the QSEE6800
+
H, observe the
following:
•
If you make changes to certain parameters, other related parameters
may also be affected.
•
When you change a parameter, the effect is immediate. However,
the module requires up to 30 seconds to save the latest change.
After 30 seconds, the new settings are saved and will be restored if
the module loses power and must be restarted.
Recalling Factory Default Parameter Settings
describes all of the parameter settings for the
QSEE6800
+
H, including the original factory defaults. To return this
module to its factory default settings, you can either reset each
parameter individually or do a global recall following this procedure:
1. Rotate the hex switch to the global recall parameter “F
.
”
2. Toggle the navigation switch to “On.”
Use an available 6800
+
software control option to aid in viewing,
setting, and confirming the parameter value.
Reading Software and Hardware Versions
The current software version of your QSEE6800
+
H module can only
be viewed using a CCS-enabled control panel or a CCS software
application, such as Pilot or
+
Pilot Lite. See your
NUCLEUS
Installation and Operation Manual
,
RCP-CCS-1U Installation and
Operation Manual,
CCS software application user manual
,
or CCS
software application online help for information on viewing software
and hardware version numbers.
Note
Calling factory defaults resets
all control parameters and alarm
settings for the QSEE6800
+
H
module and its input signals.
