QSEE6800
+
H Installation and Operation Manual
23
Chapter 3: Card-Edge and Parameter Operation
Using QSEE6800
+
H Card-Edge Controls
QSEE6800
+
H card edge controls consist of a Hex switch and
Navigation toggle switch. (See
.) In addition, a series of eight
status LEDs on the card edge indicate the corresponding parameter
options and values.
Figure 3-1.
QSEE6800
+
H Card Edge Controls
Follow these steps to change the QSEE6800
+
H parameter settings:
1. Rotate the hex switch to the parameter number (1 to 9) or letter
(A to F) of the option you want to view or set.
2. Toggle the navigation switch to select and set the value of the
chosen parameter.
lists all of the card-edge parameters for
QSEE6800
+
H.
Legend
Bold
option = Indicates that this is the default setting for the parameter.
[RO] = Indicates that parameters are read-only/feedback, and cannot be
used to select controls.
Note
For best results, use the
available 6800
+
software
control options (serial/local or
Ethernet/remote) to aid in
viewing, setting, and confirming
parameter values.
Hex switch (Mode
select rotary switch)
Navigation toggle
switch
Note
The sequence of options listed
in the Options column mirrors
the sequence achieved when
you move the Navigation
Toggle switch up.
All parameters clip unless
otherwise indicated.
