26
QSEE6800
+
H Installation and Operation Manual
Chapter 3: Card-Edge and Parameter Operation
Setting QSEE6800
+
Remote Control
Parameters
lists all of the remote control parameters and options for the
QSEE6800
+
H. To access these parameters, you must use
+
Pilot Lite or
CCS control software such as Pilot or Navigator. See your software user
manual and
Chapter 4: “CCS Operation” on page 41
for information on
controlling the module.
All parameters clip unless otherwise indicated
.
Legend
Bold
option = Indicates that this is the default setting for the parameter.
[RO] = Indicates that parameters are read-only/feedback, and cannot be
used to select controls.
Table 3-2.
Parameter Options—QSEE6800
+
H Modules—Remote Control Only
Parameter Name
1
Function
Options
Network
IP Address
Specifies the module’s IP address
String
(Initial value:
192.168.100.252
)
Subnet Mask
Specifies the module’s subnet mask String
(Initial value:
255.255.255.0
)
Gateway
Specifies the module’s gateway
address
String
(Initial value:
192.168.100.252
)
Multicast IP address
Specifies the IP address from which
multicasts are broadcast
String
(Initial value:
239.1.1.1
)
Multicast TTL
Specifies the time-to-live of the
multicast
range: 0 to 9 (
3
)
Apply Changes
Saves the Network settings to the
module
• Yes
•
No
Call Factory Default
Restores the factory default
parameters and alarm settings for
the QSEE6800
+
H module and its
inputs
• Yes
• No
Soft Reboot
Reboots the card remotely
• Reboot
•
----
