36
QSEE6800
+
H Installation and Operation Manual
Chapter 3: Card-Edge and Parameter Operation
Trigger (s)
Decide how long an alarm condition must exist (in
seconds) before the alarm is triggered. If the alarm
level is reached for less time than the
Trigger
duration,
the alarm will not trigger. Choose any duration from 0
to 7200 (or 2 hours). If this option is set to 0 and the
alarm condition exists for any period of time, the alarm
will trigger.
Clear (s)
Decide how long the alarm condition must abate before
the alarm to be turned off. Choose any duration,
measured in tenths of a second, from 0 to 7200 (or 2
hours). If this option is set to 0 and the alarm condition
ceases for any period of time, the alarm will clear.
Ack
Click here to allow other users on the network to see
that you have acknowledged an active alarm.
Table 3-7.
Alarm Options
(Continued)
Alarm Option Description
