4-6
RF-7800B
CONFIGURATION
R
4.4
CONFIGURATION PARAMETERS
The BGAN terminal includes its own internal web interface. To access the web interface,
a.
Open a compatible Web Browser.
b.
Type in the Ethernet IP address of the BGAN terminal (for example, http://192.168.128.100). Refer to
Initial Turn-On / Check for detailed instructions. The web interface opens up to the
.
4.4.1
Configuration
See
. The Configuration page is used to configure the following BGAN terminal parameters.
BGAN Terminal Local IP Address
: Use this to change the Ethernet IP address of the BGAN terminal from the
default 192.168.128.100 IP address. All four octets are available to change. Select
Apply
after changing the Ethernet
IP address on this page. The IP address ranges for the DHCP server, the Network Connection page and Automatic
Network Connection page will also be changed automatically. Changes to this field take affect after the BGAN
terminal is rebooted.
Terminal Subnet Mask:
Use this to change the Subnet Mask of the BGAN Terminal. The default is 255.255.255.0.
All four octets are available to change. Select
Apply
after changing the Ethernet IP address on this page.
NOTE
Only the most significant 29 bits of the Subnet Mask can be
set. The maximum value that can be entered is
255.255.255.248.
BGAN Terminal Mode
: Provides the ability for the BGAN Terminal to work in multiple modes. Refer
for more detailed information on configuration and operation.
•
NAT Mode. Use this for multiple direct computer connections.
•
Relay Mode. Use this for single direct router connection.
•
Bridge Mode. Use this for direct Harris radio connection.
DHCP Server (Enable/Disable)
: Use this to allow an automatic IP address allocation to the computer(s) connected
to the BGAN Terminal.
NOTE
The Ethernet IP address of the terminal can be modified along
with disabling the DHCP Server. If the Ethernet IP address of
the terminal is forgotten, remove the USIM card and restart
the BGAN terminal. With the USIM card not present, the
DHCP Server will automatically be enabled, allowing the user
to configure the BGAN Terminal's Ethernet IP address and
DHCP Server settings.
Summary of Contents for RF-7800B-DUO24
