8 – English
OPERATION
WARNING:
Do not allow familiarity with
products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recom
-
mended by the manufacturer of this product. The use
of attachments or accessories not recommended can
result in serious personal injury.
WARNING:
Verify that all guards and tubes are in place prior to use.
If the blower is dropped, stop blower and verify that
no damage has occurred. If any guard, part, or tube
is damaged or missing, do not use blower until it has
been repaired or replaced by a qualified service center.
Use of blower with damaged or missing guards, parts,
or tubes can result in serious personal injury or further
damage to the blower.
NOTICE:
Before each use, inspect the entire product for dam-
aged, missing, or loose parts such as screws, nuts,
bolts, caps, etc. Tighten securely all fasteners and caps
and do not operate this product until all missing or
damaged parts are replaced. Please contact customer
service or an authorized service center for assistance.
NOTICE:
This product is designed to be powered by either a
HART 20V battery pack (DC mode) or by electric power
(AC mode). The power mode is selected by sliding the
power selection door to the desired power source and
either installing an approved battery pack or extension
cord as described in this manual.
APPLICATIONS
You may use this product for the purposes listed below:
Clearing hard surfaces such as driveways and walkways
Keeping decks and driveways free from leaves and pine
needles
WARNING:
Always remove the battery pack or disconnect the tool
from the power supply and keep hands clear of the
power switch when carrying, transporting, assembling
parts, making adjustments, cleaning, or when not in
use. Following these instructions will prevent acciden
-
tal starting that could cause serious personal injury.
WARNING:
Make sure the latches on the battery pack snap in place
and the battery pack is fully seated and secure in the
blower battery port before beginning operation. Failure
to securely seat the battery pack could cause the bat-
tery pack to fall out, resulting in serious personal injury.
INSTALLING/REMOVING BATTERY PACK
See Figure 3.
Slide power selection door over power receptacle until it
clicks into place.
Insert the battery pack into the product as shown.
Make sure the latch snaps into place and the battery pack
is secured before beginning operation.
Depress the latch to release and remove the battery pack.
