8 – English
FILLING THE TANK
See Figure 5.
WARNING:
Before filling the tank, always remove the battery pack.
Wipe up any spills before inserting the battery pack.
Following this rule will reduce the risk of electric shock
and corrosive liquids entering the battery pack, which
can cause battery pack failure including short circuit
resulting in smoke, fire, and/or serious personal injury.
WARNING:
Always follow the chemical manufacturer’s instructions
printed on their product labeling for use, cleaning, and
storage. Do not combine chemicals.
Clean thoroughly
after each use, following the instructions in the
Main-
tenance
section of this manual. Chemicals should be
stored out of the reach of children. Failure to do so may
result in serious personal injury.
WARNING:
Do not allow conductive or corrosive fluids to get inside
the battery pack. If conductive or corrosive fluids are
spilled on the battery, refer to the instructions in your
battery operators manual.
When adding spray solutions, you may add water and the
desired chemical solution directly into the tank, or use a
solution that has been premixed in a separate container,
then poured into the sprayer, using a funnel if needed. For
either method, remember:
Liquids used must be as thin as water. Thicker liquids
will not spray properly.
Do not overfill the tank.
NOTE:
If using a measuring container or funnel to fill the
tank, be sure to thoroughly clean and rinse these items after
use. If premixing the spraying solution, rinse the container
used for mixing.
To fill:
Remove the battery pack.
Unscrew the cap and remove it from the tank.
Fill the tank with the desired amount of liquid (up to 1 gal-
lon).
NOTE: To ensure proper operation of the sprayer, do
not fill past the max fill line.
Screw the cap back onto the sprayer, making sure it is
tightened securely.
NOTE:
Wipe the outside of the tank with a dry cloth and
clean up any spills before inserting the tank.
Reinstall the battery pack.
NOTE:
If using a measuring container other than the mea-
suring cap, or if using a funnel to fill the tank, be sure to
thoroughly clean and rinse these items after use. If premix
-
ing the spray solution, rinse the container used for mixing.
NOTICE:
It is important to thoroughly clean the unit after each
use. Allowing liquid to remain in an idle tool for an
extended period may cause its moving pieces and
connectors to seize up.
INSTALLING/REMOVING BATTERY PACK
See Figure 6.
WARNING:
Always remove battery pack from your tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
To install:
Align the raised rib on the battery pack with groove in the
battery port and place the battery pack in the tool.
Make sure the latch on the battery pack snaps in place
and that the battery pack is secured in the tool before
beginning operation.
To remove:
Depress the latch on the battery pack to release the bat-
tery pack and remove it from the tool.
For complete charging instructions, see the operator’s
manuals for your battery pack and charger.
WARNING:
Risk of fire or explosion. Spray area must be well-
ventilated and away from sparks or flames.
TURNING THE SPRAYER ON/OFF
See Figures 7 - 8.
To turn the sprayer
ON
, depress the ON/OFF button.
To start the flow of liquid at the spray wand, depress the
trigger.
To stop the flow of liquid at the spray wand, release the
trigger.
To turn the sprayer
OFF
, depress the ON/OFF button
again.
OPERATION
