9 – English
MAINTENANCE
Insert the line into the anchor hole in the upper part of the
spool. Wind the line around the upper part of the spool
clockwise, as shown by the arrows on the spool. Place
line in the slot on upper spool flange, leaving about 6 in.
extended beyond the slot. Do not overfill. After winding
the line, there should be at least 1/4 in. between the
wound line and the outside edge of the spool.
Replace the plastic retainer, spool, and the spool retainer.
Refer to
Spool Replacement
earlier in this manual.
STORING THE TRIMMER
Remove the battery pack before storing.
Clean all foreign material from the trimmer.
Store it in a place that is inaccessible to children.
Keep away from corrosive agents such as garden chem
-
icals and de-icing salts.
REPLACEMENT PARTS
0.065 in. Diameter Round
Replacment Spool ............................................ HAC165RL
0.080 in. Twisted Replacment Spool ............... HAC180RL
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Line will not advance when using
the auto-feed head
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Lubricate with silicone spray.
Install more line. Refer to
Line Replace-
ment
earlier in this manual.
Pull line while pressing button.
Remove line from spool and rewind.
Refer to
Line Replacement
earlier in
this manual.
Grass wraps around boom
housing and string head
Cutting tall grass at ground level.
Cut tall grass from the top down to pre-
vent wrapping.
Motor fails to start when switch
trigger is depressed
Battery is not secure.
Battery is not charged.
Shaft not connected completely
To secure the battery pack, make sure
the latch snaps into place.
Charge the battery pack according to the
instructions included with your model.
Make sure shaft trimmer is securely
seated in the coupler on the power head.
