Hartig+Helling UFB 90 Operating Instruction Download

Page: 4 / 20

-6-

-7-

Operating instructions

UFB 90 is a programmable universal
remote control with extra large keys
– ideal for the elderly. The functions of
2 devices can be simultaneously con-
trolled using this remote.

The following types of devices can be op-
erated:

– TV set

CBL – video recorder or DVD player, SAT

receiver, set-top box

Scope of delivery

1 x UFB 90
1 x operating instructions

Special features

• extra large keys – ideal for the elderly
• for operating: TV set and video recorder

or DVD player, SAT receiver, set-top box

•  suitable for over 900 models
•  comprehensive code library
•  programmable either via code-search or

by using the enclosed number code

Operating elements

1. MUTE

mute

2. TV/VCR

device selection: TV set/
video recorder

3. POWER

On/Off

4. VOL + –

volume up/down

5. CH + –

programme up/down

6. Programme

numbers

0-9, 1/11,

2/12

programme selection

7. TV

device selection: TV set

8. CBL

device selection: video
recorder or DVD player,
SAT receiver, set-top box

9. SET

required for programming

Insert/replace batteries

Two mignon AA batteries are required for
the remote (not included in delivery). We
recommend two of our H+H MGA 4 alkaline
batteries.

1. Open the battery compartment lid on the

back of the remote.

2. Insert two Mignon batteries – observe

the correct polarity (+/-).

3. Close the battery compartment lid again.

Note! It is not necessary to programme
the remote again after replacing batter-
ies.

Programming

You may programme the remote manually
or use the search function.
When programming manually, please en-
ter the device code shown in the code list.
When using the search function, all the
codes available in the library are tried in se-
quence.

5.1

Manual programming

1. Find the appropriate code(s) for your de-

vice in the code list to enable you to en-
ter the number sequence promptly.

2. Switch on the device you wish to operate

with the remote.

3. Press and hold down the SET key using a

sharp object. Press the device key (TV or
CBL), whilst holding down the SET key,
for the POWER key LED to light up.

4. Now enter the three-digit code which

you have found in the code list for your
device. The red LED conﬁrms each key
entry by brieﬂy lighting up. Start with the
ﬁrst code if more than one code is given.

5. The red LED switches off after the last

letter of the code has been entered.

Should you have entered a code which is
not in the list, the LED will ﬂash twice af-
ter entry of the last number and then light
up again for you to enter a valid code.

6. Point the remote at the device and check

whether it reacts to the remote.

7. Should the device not react to the ﬁrst

code number in the code list, repeat
steps 3 to 6 using the second listed code
number. More than one code may be ap-
plicable to a device. Try another code if
not all the functions react to the remote
controller.

8. Note down the codes that best match

your device on the back of the remote to
facilitate renewed entry if required.

Note! If no key is pressed in a 10 second
period, programming is prematurely ter-
minated.

5.2

Programming using

the search function

1. Switch on the device you wish to control

with the remote.

2. Press and hold down the SET key using a

sharp object. Press the device key (TV or
CBL), whilst holding down the SET key,
for the POWER key LED to light up.

3. Release both keys again and press

the SET key once again brieﬂy, for the
POWER key LED to ﬂash.