51
21
Ⓐ
Ⓑ
Ⓒ
Ⓓ
Ⓔ
Ⓖ
Ⓕ
Operating instructions
Proper and intended use
The four-indent crimping tool (09 99 000 0890) is used for crimping Han
®
M23
series crimp contacts with conductor cross-sections from 0.08 mm² to 2.5 mm².
Crimping sequence
1. Refer to the “Crimping depth settings for Han
®
M23 crimp contacts” table (on
the second following page) for the locator setting and the exact crimping depth
required for the contacts you are using.
Adjust the four-indent crimping tool according to the values (refer to the section
“Adjusting the locator” and “Adjusting the crimping depth”).
2. Insert the contact into the tool’s opening until is in the speci
fi
ed crimping
position.
3. Secure the contact by carefully closing the four-indent crimping tool until it
reaches its
fi
rst catch-lock position.
►
The inserted contact is now secured in this position so that it cannot fall out.
4. Insert a properly stripped (refer to speci
fi
cations) conductor into the crimp
contact.
5. Press the crimping tool’s handles together in order to crimp the contact. Press
the tool’s handles together until they reopen automatically.
6. Remove the crimped contact.
NOTICE
Operating principle of the four-indent crimping tool
The four-indent crimping tool operates according to forced
completion functionality: you must press the handles
together as far as possible (until the end stop position) and
then the tool will open automatically.
Adjusting the crimping depth
In order to ensure the best error-free crimp connection, the crimping depth (the gap
between the crimping dies) must properly correspond to the type of contact and
conductor diameter in use. You must use the proper setting for the contact!
These settings are found in the table on the second following page.
Adjusting the locator
Raise the locator
Ⓔ
until it can be turned past the latch detent (indicated by
arrow
Ⓖ
). Turn the locator to the position speci
fi
ed in the “Crimping depth settings
for Han
®
M23 crimp contacts” table. Then let it snap into the latch detent.
NOTICE
Direction of rotation when adjusting the crimping depth
When the locator or
fi
ne-settings dial are turned clockwise,
the crimping depth is reduced. When they are turned
counter-clockwise, the crimping depth is increased.
Crimping tool for signal contacts 09 99 000 0890
Conductor cross-section 0.08 to 2.5 mm²
Ⓐ
Tool opening
Ⓑ
Settings dial (with 0.01 mm pitch)
Ⓒ
Settings scale (with 0.2 mm pitch)
Ⓓ
End stop
Ⓔ
Locator
Ⓕ
Hex. socket screw
Ⓖ
Latch detent (indicated by arrow)
Han
®
M23 Signal
Crimping tools
Summary of Contents for Han M23
Page 1: ...HARTING Han M23 Circular Connectors ...
Page 4: ...51 04 Han M23 Signal ...
Page 28: ...51 28 Han M23 Power Hybrid ...
