51
40
Ⓐ
Ⓑ
Ⓒ
Ⓓ
Ⓔ
Ⓖ
Ⓕ
Proper and intended use
The crimping tool 09 99 000 0896 is a four-indent crimping tool for processing signal
and power contacts of the series Han
®
M23. It is suitable for crimping contacts and
stranded wires with cross-sections between 0.14 mm² and 4 mm².
Crimping sequence
1. Refer to the “Crimping depth settings for Han
®
M23 crimp contacts signal” table
(on the following pages) for the locator setting and the exact crimping depth
required for the contacts you are using.
Adjust the crimping tool for power and signal contacts according to the values
(refer to the section “Adjusting the locator” and “Adjusting the crimping depth”).
2. Insert the contact into the tool
’
s opening until it is in the speci
fi
ed crimping
position.
3. Secure the contact by carefully closing the four-indent crimping tool until it
reaches its
fi
rst catch-lock position.
►
The inserted contact is now secured in this position so that it cannot fall out.
4. Insert a properly stripped (refer to speci
fi
cations) conductor into the crimp
contact.
5. Press the crimping tool’s handles together in order to crimp the contact. Press
the tool’s handles together until they reopen automatically.
6. Remove the crimped contact.
NOTICE
Operating principle of the crimping tool for power and
signal contacts
The crimping tool 09 99 000 0896 operates according to
forced completion functionality: you must press the handles
together as far as possible (until the end stop position) and
then the tool will open automatically.
Adjusting the crimping depth
In order to ensure the best error-free crimp connection, the crimping depth (the gap
between the crimping dies) must properly correspond to the type of contact and
conductor diameter in use. You must use the proper setting for the contact!
These settings are found in the table on the second following page.
Adjusting the locator
Raise the locator
Ⓔ
until it can be turned past the latch detent (indicated by
arrow
Ⓖ
). Turn the locator to the position speci
fi
ed in the “Crimping depth settings
for Han
®
M23 crimp contacts signal” table. Then let it snap into the latch detent.
NOTICE
Direction of rotation when adjusting the crimping depth
↻ clockwise ⇒ reduce crimping depth
↺ counter-clockwise ⇒ increase crimping depth
Operating instructions
Crimping tool for power & signal contacts 09 99 000 0896
Conductor cross-section 0.14 to 4 mm²
Ⓐ
Tool opening
Ⓑ
Settings dial (with 0.01 mm pitch)
Ⓒ
Settings scale (with 0.2 mm pitch)
Ⓓ
End stop
Ⓔ
Locator
Ⓕ
Hex. socket screw
Ⓖ
Latch detent (indicated by arrow)
Han
®
M23 Power / Hybrid
Crimping tools
Summary of Contents for Han M23
Page 1: ...HARTING Han M23 Circular Connectors ...
Page 4: ...51 04 Han M23 Signal ...
Page 28: ...51 28 Han M23 Power Hybrid ...