Trove1HC1R Installation Guide
- 5 -
THC1R:
Configuration of Altronix Power Supply and/or Sub-Assembly Boards
1. Fasten spacers onto metal pems configuration (A), (B) (C) of backplane depending on the board
(Fig. 5, pg. 5)
.
2. Position access controller module over corresponding spacers and fasten screws into spacers
(Fig. 5a, pg. 5)
.
Position Chart for the Following Altronix Models:
Altronix Power Supply/Charger or Sub-Assembly
Pem Mounting
eFlow4NB, eFlow6NB, eFlow102NB, eFlow104NB, AL400ULXB2, AL600ULXB,
AL1012ULXB, AL1024ULXB2, ACMS8(CB) or ACM8(CB)
A
ACM4(CB), MOM5, PD4UL(CB), PD8UL(CB), PDS8(CB), PD16W(CB) or VR6
B
DP4(CB)
C
Configuration of Hartmann Boards:
1. Align the Hartmann Controls boards on the backplane to match the boards’ mounting holes with
corresponding pems.
2. Fasten spacers (provided) to pems that match the hole pattern for Hartmann Control boards
(Fig. 5, 5a, pg. 5)
.
Note:
Hartmann Controls boards must be properly grounded.
Please use provided metal spacers for the lower right mounting holes
(Fig. 5, pg. 5)
.
3. Mount Hartmann Controls boards to spacers utilizing provided 5/16” pan head screws
(Fig. 5a, pg. 5
.
4. Fasten backplane to Trove1 enclosure utilizing lock nuts (provided).
Fig. 5
A
Metal
Spacer
Placement
for Altronix
Power
Supplies
B
B
C
PRS_MASTER
Metal Spacer
PRS_TDM
or
PRS_IO8
Metal Spacer
PRS_TDM
or
PRS_IO8
Metal Spacer
PRS_TDM
or
PRS_IO8
Metal Spacer
PRS_TDM
or
PRS_IO8
Metal Spacer
Pem
Spacer
Backplane
Power Supply
or
Sub-Assembly
Pan Head Screw
Fig. 5a
