INSTALLATION AND REMOVAL
61-00-75
Propeller Owner’s Manual
175
Page 3-45
Rev. 1 Jun/11
G. Installing F Flange Propeller Models HC-83(X,V)F-2( )( )
Refer to Figure 3-10.
CAUTION
:
INSERT THE DOWEL PINS INTO
THE PROPELLER FLANGE USING A
BRASS HAMMER OR EQUIVALENT
TOOL TO PREVENT DAMAGE TO THE
DOWEL PINS. THE DOWEL PINS ARE
AN INTERFERENCE FIT WITH THE
PROPELLER FLANGE.
(1) Insert two dowel pins (Table 3-1) through the threadless
holes in the propeller flange, flush with the propeller
side of the hub flange. The dowel pins will protrude from
the engine side of the hub flange to engage the engine
flange.
WARNING
:
CLEANING AGENT MEK IS FLAMMABLE
AND TOXIC TO THE SKIN, EYES AND
RESPIRATORY TRACT. SKIN AND EYE
PROTECTION ARE REQUIRED. AVOID
PROLONGED CONTACT. USE IN A WELL
VENTILATED AREA.
(2) Clean the engine flange and propeller flange with Quick
Dry Stoddard Solvent or MEK.
WARNING
:
USE CAUTION DURING INSTALLATION
IF THE START LOCKS HAVE BEEN
ENGAGED TO FACILITATE INSTALLATION
OF THE SPINNER BULKHEAD. IF THE
BLADES ARE RELEASED SUDDENLY,
THE EXTREME FORCE CAN CAUSE
SERIOUS INJURY AND DAMAGE TO THE
PROPELLER.
(3) If the spinner bulkhead is to be installed and is not
already in place, perform the following steps:
NOTE
: The start locks must be engaged to provide
access to the spinner mounting bolts when
installing the spinner bulkhead.
(a) Install the spinner bulkhead facing toward the
engine.
OBSOLETE PROPELLER MODELS. SEE COVER PAGE
WARNINGS AND SERVICE BULLETIN HC-SB-61-331
