INSTALLATION AND REMOVAL
61-00-75
Propeller Owner’s Manual
175
Page 3-15
Dec/05
C. Installing F Flange Propeller Models
HC-82(X,V)F-1( )( )( ) and HC-82XF-6( )( )( )
Refer to Figure 3-1
CAUTION
:
INSERT THE DOWEL PINS INTO
THE PROPELLER FLANGE USING A
BRASS HAMMER OR EQUIVALENT
TOOL TO PREVENT DAMAGE TO THE
DOWEL PINS. THE DOWEL PINS ARE
AN INTERFERENCE FIT WITH THE
PROPELLER FLANGE.
(1) Insert two dowel pins (Table 3-1) through the threadless
holes in the propeller flange, flush with the propeller
side of the hub flange. The dowel pins will protrude
from the engine side of the hub flange to engage the
engine flange.
(2) Slide the spinner bulkhead onto the propeller flange
OD.
(3) Align the spinner bulkhead mounting holes with the
holes in the four tabs that are bolted to the propeller
hub.
(4) Install the spinner bulkhead attachment bolts, washers,
and self-locking hex head nuts to hold the spinner
bulkhead to the hub flange mounted tabs.
(5) Torque the spinner attachment bolts and self-locking
hex head nuts in accordance with Torque Table 3-2.
(6) Clean the engine flange and propeller flange with Quick
Dry Stoddard Solvent or MEK.
(7) Lubricate the specified shaft O-ring (Table 3-1) with
engine oil and install it on the engine shaft.
OBSOLETE PROPELLER MODELS. SEE COVER PAGE
WARNINGS AND SERVICE BULLETIN HC-SB-61-331
