Propeller Owner’s Manual
139
INSTALLATION AND REMOVAL
61-00-39
Page 3-52
Rev. 17 Apr/20
CAUTION:
THE ROD END CAP MUST BOTTOM
ON THE PUSH ROD SPOOL WHEN
INSTALLED.
(23) Install the rod end cap onto the threaded end of the push
rod spool.
NOTE: Do not tighten the set screw in the rod end
cap.
(a) Mark the location of the set screw on the rod and
then remove the end cap unit.
(b) File a flat, tangent to the rod, no deeper than the
depth of the threads at the marked location of the set
screw. Refer to Figure 3-17.
(24) Install the check nut onto the threaded end of the push
rod spool.
(25) Install the bushing onto the threaded end of the push rod
spool.
(26)Install the rod end fitting onto the threaded end of the
push rod spool.
(27) Install the C-3317-006 O-ring in the cavity at the rear
end of the push rod spool.
Filed Rod for Set Screw
Figure 3-17
PUSH ROD SPOOL
FILED FLAT
W10138
