Propeller Owner’s Manual
139
INTRODUCTION
61-00-39
Page 1-9
Rev. 17 Apr/20
6. Special Tooling and Consumable Materials
(Rev. 1)
A. Special Tooling
(1) Special tooling may be required for procedures in this
manual. For further tooling information, refer to Hartzell
Propeller Inc. Illustrated Tool and Equipment Manual
165A (61-00-65).
(a) Tooling reference numbers
appear with the prefix
“TE” directly following the tool name to which they
apply. For example, a template that is reference
number 133 will appear as: template TE133.
B. Consumable Materials
(1) Consumable materials are referenced in certain sections
throughout this manual. Specific approved materials are
listed in the Consumable Materials chapter of Hartzell
Propeller Inc. Standard Practices Manual 202A
(61-01-02).
(a) Consumable material reference numbers appear
with the prefix “CM” directly following the material
to which they apply. For example, an approved
adhesive that is reference number 16 will appear as:
adhesive CM16. Only the material(s)
specified
can
be used.
7. Safe Handling of Paints and Chemicals
(Rev.1)
A. Instructions for Use
(1) Always use caution when handling or being exposed to
paints and/or chemicals during propeller overhaul and/or
maintenance procedures.
(2) Before using paint or chemicals, always read the
manufacturer’s label on the container(s) and follow
specified instructions and procedures for storage,
preparation, mixing, and/or application.
(3) Refer to the product’s Material Safety Data Sheet
(MSDS) for detailed information about the physical
properties, health, and physical hazards of any paint or
chemical.
