14
4.6 Completion and Cleanup
At completion of operation, the auger needs to be moved into storage
position. Make sure that the entire work area is clean, remove all
supports and wheel chocks, move auger out of working position, and
fully lower the auger (see lowering procedure below).
The proper steps for clean out of the auger are as follows:
1. Disengage power source; lower the auger into transport position.
There will be no clicking sound.
2. Turn handle clockwise until you hear two clicks. This locks the brake.
3. Shut off tractor and lock out power.
4. Move intake hopper into transport position and latch with safety
chain.
5. If necessary, clean out grain using small shovel or other tool.
WARNING:
Do not leave auger in raised position when not in use. Auger could drop
rapidly in case of hydraulic failure. High winds may also upset the
auger. Because the hydraulic scissor lift is faster than a hand crank
system, use extra caution and clear area of personnel before raising or
lowering auger.
4.7 Lowering the Auger
Check that auger and hose couplers are securely attached to your
tractor.
You may need to raise the auger discharge end up and out of bin or
storage facility before proceeding.
Remove wheel chocks, and check that the area around and under the
auger is clear of debris and unauthorized personnel. Wheels must be
free to move when raising or lowering the auger.
Slowly pull away from bin or storage facility. As soon as you are clear,
engage the hydraulics and lower the auger. Once valves are open, the
auger lowers by gravity. Rate of descent increases the closer the auger
gets to the down position. Be cautious.
Transport auger only in fully lowered position.
Summary of Contents for H13114XT
Page 41: ...43 ...
