Instructions for installation and use
p. 6/28
●
Only install one sauna heater in the cabin. The Qube sauna
heater must not be used together with other sauna heaters in
a sauna cabin.
●
The roof and walls of the sauna cabin must be manufactured
from low-resin, untreated or thermally treated wood, e.g. Nordic
spruce, hemlock, pine or fir, or from laminated wooden materi
-
als. If laminated wooden materials are used, make sure that the
adhesive used in them does not give off formaldehyde. If other
materials than wood are used in the sauna cabin, these materi-
als must be heat-resistant and corrosion-resistant and must not
cause any negative effects on the health of the sauna users.
●
The height of the sauna cabin must be at least 2.0 m.
● Observe the specifications on volumes and on ventilation of the
sauna cabin in chapter
10. Technical data
.
●
When positioning the sauna heater, observe the minimum safety
distances (see chapter
4.2. Safety distances
).
●
Also comply with the regulations applicable at the installation
location.
●
For your own safety, consult your supplier in the event of prob-
lems that are not explained in sufficient detail in the installation
instructions.
Summary of Contents for sentiotec Qube
