Online mode (WiFi network available)
All control units are shipped ready for online mode. For offline mode, skip this section.
Step 1
Turn the control box on. It will beep fast for 30 seconds or so. It will then change to a slow beep. It
is now transmitting a WiFi signal for you to connect to, so that you can tell the box which network
to use.
Step 2
Connect to the “harvst-wifi” network on your phone or tablet. When connected, you should be
prompted to “log into Wifi network” or similar, and be automatically directed to a screen step 3
below. If youʼre not automatically redirected, read step 6.
Step 3
Once connected to
ʻharvst-wifiʼ you should be
redirected to the first setup
screen (below). Click to
Configure WiFi
. Wait while it
scans for networks.
Step 4
Click
the Wifi network you
want your control box to use
so that it appears in the SSID
box, then enter the WiFi
password and hit
Save
.
Step 5
Once you have saved, the
control box will attempt to
join the network and youʼll
see the screen below. When
the unit connects, youʼll hear
a celebration beep then the
fast beeping will resume for
a short while, finishing with a
double beep to indicate that
WiFi is now connected.
If you don't get this set of
beeps, it may still have
registered the connection.
Turn the control box off and
restart the process if
required. Some networks do
require a couple of attempts
to join.
Step 6
If you are not redirected to the WiFi setup page when you connect to “harvst-wifi” in step 3 then
you will need to open an internet browser (eg Safari, Chrome) and go to
which
will be the screen in step 3 above.
8
