6. Fit connecting hose
Fit the short (approx 50cm) section of
black hose between the elbow joints on
the top and bottom pipes, on the left.
The hose runs around the front of the
bottom shelf (the side closest to the
doors).
TIP
: You will need to warm the ends of
the hose in hot water for a few seconds
to soften it before fitting.
Parts
1 x connecting hose
7. Fit the rear panels
2 x Black rear panel
3 x 20mm wide black
connecting strip
2 x 1440mm long H-section
2 x 20mm M4 bolt, penny
washer and nut
Put the penny washer on the outside.
Fit the panels so that the holes for the
control system are at top right.
From behind, drop the two large
panels into the slot on the timber base,
and outwards into the slots in the end
panel uprights.
Slide the H-section down on the inner
sides of the end panels. It doesn't
matter whether the long leg is inside or
outside.
Next, fit the three thin black strips. The
long one goes in first. Slide them down
the gap to tighten it all up. Leave gaps
between the strips, at the hole in the
centre of each shelf, for the bolts which
hold the panels to the frame.
We've found the best way is to slide up
one of the large panels so you can get a
hand inside to fit the nut on the bolt.
