Hatco FLAV-R-FRESH FDW-1 Installation And Operating Manual Download

Page: 10 / 60

Form No. FDWCEM-1002

DRAINING THE RESERVOIR

WARNING

To avoid any injury, turn the power off to the unit and allow
to cool before draining.

It is recommended that the Flav-R-Fresh water reservoir be drained
prior to moving the cabinet and after removing lime or mineral
deposits from the water reservoir.

NOTE:

The drain hose assembly is located inside the cabinet

at the right front corner.

To drain the reservoir insert the drain fitting with hose into
the water outlet, located on the ceiling of the cabinet. Once
the fitting is installed, water will begin to drain from the hose.

NOTE:

Position a container to hold the water while draining.

Once the unit has finished draining, the drain assembly
can be removed by pressing the release tab and gently pulling
the fitting out.

MAINTENANCE

The Hatco Flav-R-Fresh Holding and Display Cabinets are designed
for maximum durability and performance, with minimum
maintenance. The rack motor and blower motor are permanently
lubricated and require no maintenance.

NOTE:

If the water used has an excessive amount of lime

or mineral content, follow the instructions for periodic cleaning
and deliming of the water reservoir.

REMOVING LIME & MINERAL DEPOSITS

1. Turn the power switch “off” and unplug the unit from its

power source.

2. After the unit has cooled down, drain all remaining water

out of the unit.

3. Fill the unit with a mixture of water and delimer.

NOTE:

The delimer used should be a safe, non-toxic, non-corrosive

solution. Follow the delimer’s instructions for proper mixture
of water and delimer solution.

4. Allow the unit to stand with the mixture in the reservoir

for the recommended period of time. (The time required will
vary depending on the solution used and amount of deposits
in the reservoir.)

5. After the deliming period, drain the solution from the tank.

6. Continue to fill and drain the unit with water only until

the discharge is clear.

7. Plug the cabinet power cord into its power source and fill the

unit as usual for daily operation.

NOTE:

How often this procedure must be performed depends on

the lime and mineral content of the water used for daily operation.

CLEANING

WARNING

This appliance is not of Jet-proof construction. Do not use
jet-clean-spray to clean this appliance.

WARNING

To prevent electric shock, always unplug the unit before
performing cleaning, maintenance or repair.

The Hatco Flav-R-Fresh cabinets are made of stainless steel
and aluminum. To preserve the bright finish, it is recommended that
the exterior and interior surfaces be wiped daily with a damp cloth.
Food pans should be removed and washed. Stubborn stains may
be removed with a good stainless steel cleaner or a non-abrasive
cleaner.

CAUTION

Abrasive cleaners could scratch the finish of your Flav-R-Fresh
Holding and Display Cabinet.

Clean the glass sides using a common glass cleaner. For hard-to-
clean stains, removal of the glass is suggested.

To Remove the Glass:

1. Lift the glass to be cleaned from the bottom of the cabinet.

2. Pull the lower edge away from the cabinet.

3. Carefully lower the glass until the top clears the cabinet.

To Replace the Glass:

1. Position the glass with the top edge under the cabinet lip

and raise the glass until it clears the bottom channel
of the cabinet.

2. Move the bottom of the glass towards the cabinet until the glass

rests against the cabinet frame.