4
IMPORTANT SAFETY INSTRUCTIONS
Form No. FDWCEM-1002
CAUTIONS
Locate the Display Cabinet at the proper counter height,
in an area that is convenient for use. The location should
be level to prevent the cabinet or its contents from
accidentally falling.
CAUTIONS
Water supply in excess of .75 grains of hardness per liter
(3.0 grains of hardness per gallon [GPH]) must be treated
and softened before being used. Water containing over
.75 GPL (3.0 GPH) will decrease the efficiency and reduce
the operating life of the unit.
Abrasive cleaners could scratch the finish of your
Flav-R-Fresh Holding and Display Cabinet.
WARNINGS
Overfilling can cause electrical shock. Stop filling when
low-water light goes off.
To avoid any injury, turn the power off to the unit and allow
to cool before draining.
This appliance is not of Jet-proof construction. Do not use
jet-clean-spray to clean this appliance.
For safe and proper operation, the Display Cabinet must
be located a reasonable distance from combustible walls
and materials. If safe distances are not maintained,
discoloration or combustion could occur.
Only light bulbs which meet or exceed N.S.F. Standards,
specifically designed for food holding areas must be used.
Breakage of light bulbs not specially coated could result
in personal injury and/or food contamination.
If service is required on this unit, contact your Authorized
Hatco Service Agent, or contact the Hatco Service
Department at 800-558-0607 or 414-671-6350;
fax 800-690-2966 or international fax 414-671-3976.
This product has no “user” serviceable parts. To avoid
damage to the unit or injury to personnel, use only
Authorized Hatco Service Agents and Genuine Hatco Parts
when service is required.
Genuine Hatco Replacement Parts are specified to operate
safely in the environments in which they are used. Some
aftermarket or generic replacement parts do not have
the characteristics that will allow them to operate safely
in Hatco equipment. It is essential to use Hatco Replacement
Parts when repairing Hatco equipment. Failure to use Hatco
Replacement Parts may subject operators of the equipment
to hazardous electrical voltage, resulting in electrical
shock or burn.
Summary of Contents for FLAV-R-FRESH FDW-1
Page 58: ...57 Form No FDWCEM 1002 NOTES...
Page 59: ...58 Form No FDWCEM 1002 NOTES...
