INSTALLATION
The Flav-R-Savor Large Capacity Holding and Display
Cabinets are shipped with most components installed
and ready for operation. The following installation
instructions must be performed before plugging in and
operating the cabinet.
DOOR HANDLES
Install door handles using the screws supplied.
See
Figure 5.
FLOOR SHEET
The stainless steel floor in all Flav-R-Savor units is
protected during shipping with a sheet of corrugated
cardboard. This protection
must be removed
prior to
cabinet operation.
DISPLAY RACKS
The chrome-plated display racks have Styrofoam
attached with plastic ties for protection during shipping.
This protection
must be removed
prior to cabinet
operation.
LEGS
See ACCESSORIES for installation instructions on the
optional 4" (10 cm) Adjustable Legs.
STACKING KIT
To stack one WFST onto another WFST:
CAUTION
1. Be sure the unit is mounted on a structure of
suitable strength to support the double units and
the food displayed.
2. Install the four 6” (15 cm) stainless steel legs into
the base frame, tighten securely. If the frame is not
level or rocking occurs, the bottom of each leg can
be adjusted to correct the condition.
3. Carefully position the bottom WFST unit into the
base frame assembly.
4. Remove the four top cover screws from the
painted cover and position the top stacking
brackets on the unit. Secure using the same holes
and screws.
See Figure 6.
5. Carefully position the top unit onto the bottom
unit inside the stack support brackets.
Figure 5. Door Handle Installation.
Figure 6. Stacking WFST Units.
Form No. WFSTM-0297
4
