background image

1. PRODUCT WARRANTY

Hatco  warrants  the  products  that  it  manufactures  (the

“Products”)  to  be  free  from  defects  in  materials  and

workmanship, under normal use and service, for a period of one

(1)  year  from  the  date  of  purchase  when  installed  and

maintained in accordance with Hatco’s written instructions or

18 months from the date of shipment from Hatco. Buyer must

establish the Product’s purchase date by registering the Product

with Hatco or by other means satisfactory to Hatco in its sole

discretion.
Hatco warrants the following Product components to be free

from defects in materials and workmanship from the date of

purchase (subject to the foregoing conditions) for the period(s)

of time and on the conditions listed below:

a) One (1) Year Parts and Labor PLUS One (1) Additional

Year Parts-Only Warranty:

Conveyor Toaster Elements (metal sheathed)

Drawer Warmer Elements (metal sheathed)

Drawer Warmer Drawer Rollers and Slides

Strip Heater Elements (metal sheathed)

Display Warmer Elements (metal sheathed air heating)

Holding Cabinet Elements (metal sheathed air heating)

Heated Well Elements — HW and HWB Series 

(metal sheathed)

b) Two (2) Year Parts and Labor Warranty:

Induction Ranges

c) One (1) Year Parts and Labor PLUS Four (4) Years 

Parts-Only Warranty:

3CS and FR Tanks

d) One (1) Year Parts and Labor PLUS Nine (9) Years 

Parts-Only Warranty on:

Electric Booster Heater Tanks

Gas Booster Heater Tanks 

e) Ninety (90) Day Parts-Only Warranty: 

Replacement Parts

THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN

LIEU  OF  ANY  OTHER  WARRANTY,  EXPRESSED  OR

IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED

WARRANTY OF MERCHANTABILITY OR FITNESS FOR A

PARTICULAR  PURPOSE  OR  PATENT  OR  OTHER

INTELLECTUAL  PROPERTY  RIGHT  INFRINGEMENT.

Without  limiting  the  generality  of  the  foregoing,  SUCH

WARRANTIES DO NOT COVER: Coated incandescent light

bulbs, fluorescent lights, heat lamp bulbs, coated halogen light

bulbs, halogen heat lamp bulbs, xenon light bulbs, LED light

tubes, glass components, and fuses; Product failure in booster

tank, fin tube heat exchanger, or other water heating equipment

caused  by  liming,  sediment  buildup,  chemical  attack,  or

freezing;  or  Product  misuse,  tampering  or  misapplication,

improper installation, or application of improper voltage.

2. LIMITATION OF REMEDIES AND DAMAGES

Hatco’s liability and Buyer’s exclusive remedy hereunder will be

limited solely, at Hatco’s option, to repair or replacement using

new  or  refurbished  parts  or  Product  by  Hatco  or  a  Hatco-

authorized service agency (other than where Buyer is located

outside  of  the  United  States,  Canada,  United  Kingdom,  or

Australia, in which case Hatco’s liability and Buyer’s exclusive

remedy hereunder will be limited solely to replacement of part

under  warranty)  with  respect  to  any  claim  made  within  the

applicable warranty period referred to above. Hatco reserves

the right to accept or reject any such claim in whole or in part.

In the context of this Limited Warranty, “refurbished” means a

part  or  Product  that  has  been  returned  to  its  original

specifications by Hatco or a Hatco-authorized service agency.

Hatco will not accept the return of any Product without prior

written approval from Hatco, and all such approved returns shall

be  made  at  Buyer’s  sole  expense.  HATCO  WILL  NOT  BE

LIABLE,  UNDER  ANY  CIRCUMSTANCES,  FOR

CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING

BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS

RESULTING FROM THE USE OF OR INABILITY TO USE THE

PRODUCTS  OR  FROM  THE  PRODUCTS  BEING

INCORPORATED  IN  OR  BECOMING A  COMPONENT  OF

ANY OTHER PRODUCT OR GOODS.

15

Form No. HHM-0517

LIMITED WARRANTY

Summary of Contents for FR2 Series

















Reviews: