Form No. GRPM-0307
10
MAINTENANCE
WARNING
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
WARNING
This product has no “user” serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Replacement Parts when service
is required.
WARNING
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
CLEANING
Hatco Glo-Ray
®
and Ultra-Glo
™
Portable
Foodwarmer units are designed for maximum
durability and performance, with minimum
maintenance.
WARNING
To avoid any injury, turn the power switch OFF
unplug the unit from the power source and allow
to cool completely before performing any
maintenance and cleaning.
To preserve the finish of the Glo-Ray and Ultra-Glo
Portable Foodwarmer, it is recommended that the
surfaces be wiped daily with a clean, soft, damp
cloth. Stubborn stains maybe be removed with a
good stainless steel cleaner or a non-abrasive
cleaner. Hard to reach areas should be cleaned with
a small brush and mild soap.
NOTICE
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit
marring its appearance and making it
susceptible to soil accumulation.
DISPLAY LIGHT BULB REPLACEMENT
The display light is an incandescent bulb which
illuminates the warming area. This bulb has a
special coating to guard against injury and food
contamination in the event of breakage.
To replace a bulb, disconnect the power supply and
wait until the unit has cooled. Display lamps have a
threaded base. Unscrew the bulb from the unit and
replace it with a new specially coated incandescent
bulb. Hatco shatter-resistant bulbs meet NSF
standards for food holding and display areas.
NOTE: Hatco shatter-resistant light bulbs meet NSF
standards for food holding and display areas. For
120 Volt applications, use Hatco part number
02.30.043.00. For 220, 240, 220-230 and 230-240
Volt applications, use Hatco part number
02.30.058.00.
WARNING
Only light bulbs which meet or exceed NSF
standards, specially designed for food holding
areas may be used. Breakage of light bulbs not
specially coated could result in personal injury
and/or food contamination.
Summary of Contents for Glo-Ray GR-B Series
Page 15: ...Form No GRPM 0307 13 NOTES...
